Filter
Top Products
SKU 93142 For technical questions, please call 1-800-444-3353 PAGE 6
14. Always switch to a fresh Battery Pack (15) when tool performance begins to
diminish. Severe heat is most destructive to a Battery Pack. The more heat
generated, the faster the Battery Pack loses power. A Battery Pack that gets too hot
can be permanently damaged. Never over-discharge a Battery Pack by using the
tool while tool performance is decreasing. Never attempt to discharge a tool’s Battery
Pack by continuing to pull the tool Trigger. When tool performance begins to diminish,
stop the tool, recharge the Battery Pack, and use the fresh Battery Pack for optimal
performance.
15. WARNING! Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contain chemicals known (to the State of California)
to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are: lead from lead-based paints, crystalline silica from bricks and cement
or other masonry products, arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area,
and work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
(California Health & Safety Code
25249.5, et seq.)
16. WARNING! People with pacemakers should consult their physician(s) before
using this product. Electromagnetic fields in close proximity to a heart pacemaker
could cause interference or failure of the pacemaker. In addition, people with
pacemakers should adhere to the following: Avoid operating power tools alone.
Don’t use a power tool with the power switch (Trigger) locked on. If powered via a
power cord be certain that the tool is properly grounded. A ground fault interrupt
(GFCI) system is also a good precaution. This inexpensive device is a good safety
measure because it prevents a sustained electrical shock. Properly maintain and
inspect all tools before use to avoid electrical shock.
17. WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
PRODUCT FEATURES
NOTE: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram on page 12.
1. WARNING! Always make sure the Trigger of the Cordless Drill is in its “OFF”
position, the Battery Pack (15) is removed from the Cordless Drill, and the Charger
(21) is unplugged from its electrical outlet prior to making any adjustments to the
tool. (See Figure A.)