Filter
Top Products
SKU 93302 For technical questions, please call 1-800-444-3353 PAGE 7
COLLAR (6)
Clean the Sprayer thoroughly with agents recommended by the chemical manu-
facturer. Allow the unit to air-dry. Replace the Cap, and store the Sprayer in a
clean, dry, safe location out of reach of children. (See Assy. Diagram.)
TROUBLESHOOTING
Problem Possible Solution
Unit does not spray. Make sure there is an adequate amount of
liquid in the Tank.
Pump the Hand Pump Assy. to pressurize the
system. (Do not squeeze the Trigger on the
Spray Gun Assembly when performing this
procedure.)
Make sure the Cap is screwed on tightly.
Make sure all connections to the Tank are
secure.
Make sure all connections on the Spray Gun
Assy. are secure.
Make sure the Nozzle on the Spray Gun Assy.
is clear of dirt and debris.
The spray pattern is undesirable. Adjust the Nozzle on the Spray Gun Assy. to a
“pinpoint” or “fan” pattern.
Make sure the Nozzle on the Spray Gun Assy.
is clear of dirt and debris.
INSPECTION, MAINTENANCE, AND CLEANING
1. CAUTION! Always de-pressurize the system before performing any
inspection, maintenance, or cleaning of the Sprayer.
2. Before each use, inspect the general condition of the Sprayer. Check for
misalignment or binding of moving parts, damaged or loose parts, dirt or debris
in the Filter, and any other condition that may affect the tool’s safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further
use. Do not use damaged equipment.
3. Periodically, lubricate all moving parts of the Handle Pump Assembly.
4. To clean: If using liquid chemicals, flush the interior and clean the exterior of the
the Tank (1) and empty any remaining liquid into a safe and secure container.