Filter
Top Products
SKU 93302 For technical questions, please call 1-800-444-3353 PAGE 6
2. CAUTION! Always wear eye, breathing, and skin protection. Wear ANSI
approved safety impact goggles, an ANSI approved respirator, latex gloves, and
proper safety clothing when using this product.
3. Prior to filling the Tank (1) of the Sprayer with liquid, remove the Cap (2) and
check to make sure the Filter (3) is clear of dirt and debris. If necessary, remove
the Filter and thoroughly clean. Next, insert the Filter back into the opening of
the Tank. Fill the Tank with up to 4 gallons of liquid. Then, replace the Cap on
the Tank. (See Assy. Diagram.)
4. NOTE: The Sprayer is heavy when completely filled with liquid. Always get
assistance when strapping the Sprayer onto your body. If necessary, adjust the
Strap Assembly (7) for comfort. (See Assy. Diagram.)
5. Always make sure other adults, children, and animals do not have access to the
area(s) in which you intend to chemically treat.
6. Grip the Handle of the Spray Gun Assembly (6) firmly with your right hand.
(See Assy. Diagram.)
7. With your left hand, pump the Hand Pump Assembly (5) to build up sufficient
pressure in the Sprayer system. Once the system is pressurized (as indicated
by an increased tension on the Hand Pump Lever), you may discontinue
pumping the Hand Pump Assembly. (See Assy. Diagram.)
8. Point the Nozzle of the Spray Gun Assembly (6) toward the area to be sprayed.
Then, squeeze the Trigger on the Spray Gun Assembly to begin spraying.
(See Assy. Diagram.)
9. NOTE: The Nozzle of the Spray Gun Assembly (6) may be adjusted for a
pin-
point
spray or a
fan
spray. (See Assy. Diagram.)
10. As you spray, the system will begin to depressurize. When the distance of the
spray diminishes you will need to stop spraying momentarily. Then, resume
pumping the Hand Pump Assembly (5) to re-pressurize the system before spray-
ing again. (See Assy. Diagram.)
11. If it becomes necessary to refill the Tank (1) of the Sprayer, continue squeezing
the Trigger on the Spray Gun Assembly (6) to completely de-pressurize the
system. Remove the Cap (2) from the Tank. Check to make sure the Filter (3)
is clear of dirt and debris. Refill the Tank with liquid, and replace the Cap. Pump
the Hand Pump Assembly (5) to pressurize the system, and continue spraying.
(See Assy. Diagram.)
12. When finished spraying, de-pressurize the system. Remove the Cap (2) from