Filter
Top Products
SKU 93601 For technical questions please call 1-800-444-3353. Page 3
10. Always check hardware and assembled parts after assembling. All connections should
be tight and hardware tightened.
11. Caution: Avoid sharp edges during use and assembly.
12. Beware of operating the power tool in explosive atmospheres, such as in the
presence of flammable liquids, gases, or sawdust. Electrical products create sparks
which may ignite sawdust released from the Dust Collector, as well as other dust and fumes.
13. Carefully inspect the condition of the accessory before use and check the accessory
continually during use. If any damage is noted, stop immediately and replace the
accessory with an undamaged one. Harbor Freight Tools cannot be held responsible
for damage caused by using a damaged accessory on this product.
14. Keep the hoses away from sharp objects and excessive heat.
15. Make sure to read and understand all instructions and safety precautions, as outlined in the
manufacturer’s manual of the power equipment to which the Dust Collector Accessory Kit
will be attached.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other
construction activites, contain chemicals known [to the State of California] to cause cancer,
birth defects or other reproductive harm. some examples of these chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks and cement or other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To
reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles. (California Health & Safety Code 25249.5, et seq. )
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Unpacking
When unpacking your Dust Collector Accessory Kit, check to make sure all parts listed on page 5
are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
1-800-444-3353.
Product Overview
The Dust Collector Accessory Kit is designed to be attached to one or two power tools, and is used
for the collection of wood dust, wood chips, sand, and other light debris. The Dust Collector
Accessory Kit may be attached to table saws, band saws, sanders, router tables, shapers, jointers,
and a variety of dust collecting machines all having a 4” dust port. Due to the wide diversity of
power machinery to which the Dust Collector Accessory Kit may be attached, it is recommended
that
only
a qualified technician perform the assembly procedure.