Filter
Top Products
SKU 93632 For technical questions, please call 1-800-444-3353.
English
Page 10
PARTS LIST
#traPnoitpircseD.YTQ#traPnoitpircseD.YTQ
15mrehsaWgnirpS492rotatS1
2055x5TSwercS403bonKeldnaHedapS1
3yeKkcuhC113eldnaHedapS1
422x6mwercSdaeHpaC123esaCkcaB1
5kcuhC133paChsurB2
612mrehsaW143hsurBnobraC2
7gnisuoHraeG153redloHhsurB2
83mniP2638mtuNxeH1
9SR2006gn
iraeBllaB173tuNrofrevoC1
01pilcriC183F61x4TSwercS4
1101x7.3x3myeK393gnisuoH1
21eldnipS104eveelSrebbuR1
31raeGtuptuO114gulPdnadro
C1
4104x01mwercS124pilCdroC1
51eldnaHediS13461x4TSwercS2
6121mpilcriC144revoCeldnaH1
71214101KHgniraeBeldeeN154F81x4TSwercS2
81t
fahSdnoceS164hctiwS1
91raeGdnoceS174etalPepyT1
0221mpilcriC184055x4TSwercS2
12012180KHgniraeBeldeeN494etalPemaN1
22revoCgnisu
oHraeG105Z2.0006gniraeBllaB1
3201mpilcriC115gniR-O1
42reniateRgniraeB125gniRlaeS1
52erutamrA135raeGtsriF1
6272.806gniraeBllaB14
5tfahStsriF1
72gnihsuBgniraeB155teksaG1
82ediuGgnidniW1
NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as
replacement parts.
TROUBLESHOOTING
1. Drill operates but hole is not effectively drilled.
Possible Cause:
Inappropriate or dull drill bit.
Solution:
Try a different drill bit.
2. Drill will not turn ON.
Possible Cause:
No power source.
Solution:
Check that the power cord is plugged into an appropriate live
outlet. Check that power cord is in good condition.
Possible Cause:
Damaged Carbon Brushes.
Solution:
Unplug tool. Remove and inspect Carbon Brushes.
If glazed, they can be cleaned with a pencil eraser. If chipped, cracked or worn out, they must be
replaced. Reinstall good Carbon Brushes. Plug in tool and try again.
Possible Cause:
Damaged or burned out Rotor or Stator.
Solution:
Take to a qualified service technician
for replacement or repair.
3. Drill bit “wobbles” in Chuck.
Possible Cause:
Loose or misaligned drill bit.
Solution:
Unplug tool from power supply. Loosen drill bit in
chuck, and reinstall carefully. Tighten securely.
Possible cause:
Chuck is loose on Spindle (12).
Solution:
Tighten the Chuck onto the Spindle by turning
clockwise.