Filter
Top Products
SKU 93657 For technical questions, please call 1-800-444-3353. Page 8
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 11
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
SETUP INSTRUCTIONS
1. CAUTION! Always make sure the Power Switch (34) of the Air Compressor is
in its “OFF” position and the unit is unplugged from its electrical outlet prior to per-
forming any service, maintenance, or cleaning of the Compressor.
2. Before operating, make sure the Air Compressor is set up in a well-ventilated area,
on a flat, level, solid surface well away from any flammable objects, such as drapes.
Never paint in an area without proper ventilation, or near possible ignition sources.
OPERATING INSTRUCTIONS
To Start The Compressor:
1. Insert the Power Cord Plug (35) into the nearest 120 volt, grounded, electrical out-
let. (See Figure A.)
2. Connect an Air Brush (not included) to the Air Hose (42) of the Compressor. Use
Hose Adapter (44) if needed.
3. Turn the Power Switch (34) to its “ON” position. (See Figure A.)
POWER
SWITCH
(34)
POWER
CORD
PLUG
(35)
WATER
DRAIN
VALVE (40)
HANDLE
(30)
FIGURE A
PRESSURE
GAUGE (11)
Note: This Compressor is designed for
use with air brushes; never attempt to
operate this compressor with any other
type of painting equipment.
REGULATOR
KNOB (40)