Filter
Top Products
SKU 93682 For technical questions please call 1-800-444-3353. Page 7
Unpacking
When unpacking your Stapler, check to make sure that it is intact and undamaged. If it is damaged
or broken, please call HARBOR FREIGHT TOOLS at 1-800-444-3353.
Assembly
Your Stapler comes completely assembled. You will have to add standard 1/4” Leg Staples (not
included). The Stapler must be unplugged before adding staples. It is important that you read the
entire manual to become familiar with the product BEFORE you operate the Stapler.
1. Make certain that the Stapler is unplugged before loading staples into the Staple
Channel (2).
2. Press the Channel Release Button (5) to make the Staple Channel pop out from the
Stapler-see Figure 1.
3. Insert a full strip of Standard 1/4” Leg Staples into the Staple Channel (2). Make certain
the prongs of the staples face down into the Staple Channel (2). The Staple Channel (2)
will hold 150 staples.
4. Push the Staple Channel (2) back into the Stapler. Make certain that it is pushed all the way
back in.
5. Insert the Electrical Power Cord (6) into an outlet.
Operation
1. Insert the Electrical Power Cord (6) into the nearest 120 V outlet.
2. Decide on the location that you want the staple to go. Insert the desired edge of your paper
into the mouth of the Stapler-see Figure 1.
3. A staple will be driven into the paper when it hits the Automatic Stapling Lever (4). The
Stapler will staple up to 12 sheets at a time.
Figure 1
Insert paper
to be stapled
Staple Channel (2)
Channel Release
Button (5)