Filter
Top Products
SKU 93742 For technical questions, please call 1-800-444-3353. Page 4
18. Use proper size and type air pressure line and fittings. The recommended
air line for this tool is 3/8” ID delivering no more than 90 PSI.
19. Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.
20. Disconnect air supply before adjusting Sander or replacing Sanding Pad.
Before making any adjustments to the Sander make sure that the compressed
air is disconnected.
21. Use Sander on an appropriate work surface only. Test sander on a test
scrap of material before sanding the workpiece. Always wear ANSI approved
safety goggles during use and maintenance.
22. WARNING: Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities, contain chemicals known [to the State of
California] to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
Lead from lead-based paints
Crystalline silica from bricks and cement or other masonry products
Arsenic and chromium from chemically treated lumber
The Brass components of this product contain lead, a chemical known to the
state of California to cause birth defects (or other reproductive harm).
(California Health & Safety Code § 25249.5,
et seq.
)
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the
operator.
Unpacking
When unpacking, check to make sure the following parts are included.
Palm Random Orbital Sander
6” Backing Pad
22 mm Chrome Plated Flat Wrench
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.