Filter
Top Products
SKU 93827 For technical questions, please call 1-800-444-3353. Page 12
3. To Adjust the Angle of Cut:
A. Loosen the Angle Knob (34).
B. Pivot the Saw body in relation to the Foot (35) to adjust the angle. Read the
angle from the arrow and scale near the Angle Knob.
C. Retighten the Angle Knob (34) securely.
4. To Adjust the Depth of Cut:
A. Be sure to keep your fingers well away from the Trigger (4), Safety (21), and
Blade (10) while performing any adjustment, but especially when adjusting
the Depth, because the battery may be installed.
B. Loosen the Depth Knob (34).
C. Raise/lower the Saw body in relation to the Foot (35) to adjust the depth.
Note: Add
1
/
8
” to the depth so the Saw Blade (10) can cut through the material cleanly.
D. Retighten the Depth Knob (34) securely.
5. Make certain that both halves of the workpiece are properly supported and secured
in place. Also, make sure that the path you will be cutting along is free from all
obstructions under/on the board and that there are no obstructions in the board itself
(such as knots or hardware).
Keep your fingers AWAY from the Trigger (4) and Safety (21) until you
are lined up with the board and ready to cut.
6. Adjust the depth of cut to the shallowest setting. Insert the fully charged Battery (64)
in the Circular Saw’s handle, and make sure it snaps into place on the handle. The
depth of cut can now be adjusted to the desired setting for use.