Filter
Top Products
Page 10
SKU 93974
For technical questions, please call 1-800-444-3353
2. To ensure you don’t allow paint to build up, start moving the Spray Gun before you
Squeeze the Trigger. When you are finished spraying, release the Trigger before you
stop moving the Spray Gun. Doing so will eliminate distinct overlaps, producing a
blended (feathered) affect. See FIGURE 6 below.
Techniques
Note: Before spraying, mask all objects you do not want sprayed and lay cloths (not included)
on the floors.
1. Always keep the gun at right angles to the workpiece (See FIGURE 5). Pull the Trigger
slowly and move the Spray Gun in parallel strokes to the object being painted. Keep
the distance from the object being painted at 6” to 9”. This may slightly differ depending
on the flow adjustment and the material being sprayed. Do not stop the gun movement
while spraying. If you stop the gun for even just a slight pause while spraying, the paint
will build up and run down the workpiece.
Note: The speed of the stroke, the adjustment of the Fluid Control Knob (28a or 29, and the
distance from the workpiece, will determine how much paint is being applied. To get
the best results, try to apply two thin coats of paint versus one thick coat.
3. Clean out the gun thoroughly after EVERY use, according to the instructions
found on the next page.
FIGURE 5
Correct (90
o
)
Incorrect
(Heavier coat on one
side, uneven coverage)
(Even coverage)
FIGURE 6
(Top View)
End
Stroke
Begin
Stroke
Release
Trigger
Squeeze
Trigger