Filter
Top Products
Page 9
SKU 94186 For technical questions, please call 1-800-444-3353
ASSEMBLY INSTRUCTIONS
1. Mount the right Tool Rest (23) to the right Wheel Guard (7) using Bolt (21) and
Washer (20).
2. Mount the left Tool Rest (22) to the left Wheel Guard (7) using Bolt (21) and Washer
(20). See photo below.
3. Adjust each Tool Rest so that there is 1/16 inch (minimum) clearance from the
Grinding Wheel. At the same time, adjust each Tool Rest so that the workpiece
contacts the Grinding Wheel slightly above the center-line of the Motor Rotor (14).
Securely tighten both Tool Rests.
4. Attach the Left Spark Arrester (18-3) to the top-left Wheel Guard (7) using Washer
(18-1) and Hex Screw (18). Adjust Spark Arrestor to no closer than 1/16” to the
Grinding Wheel. Tighten Hex Screw (18). Do the same with the Right Spark Arrestor
(18-2).
5. Mount the right Eye Shield (19), secured to the Right Bracket (17), to the Wheel
Guard (7) using Hex Screw (18). See photo above. Adjust to the desired eye
protection level and securely tighten Hex Screw (18).
6. Mount the left Eye Shield (19), secured to the Left Bracket (16), to the Wheel Guard
(7) using Hex Screw (18). Adjust to the desired eye protection level and securely
tighten Hex Screw (18).
Bench Mounting
1. Select a sturdy work bench able to withstand the weight of the Bench Grinder and the
workpiece pressure exerted by the operator.
2. When the mounting location of the Bench Grinder is located, place a marker through
each of the Base (33) mounting holes.
3. Move the Bench Grinder aside and drill four 1/4 inch mounting holes into the
workbench.
4. Place Bolts (not supplied) through the Base (33) mounting holes and secure to the
workbench using hardware (not supplied).
Eye Shield
Eye Shield
Tool Rest, Right (23)
Tool Rest, Left (22)
Cover (2)
Wheel Guard (7)
Bolt (21) and Washer (20)
Base (33)
Mounting Hole x 4
Hex Screw (18)
Spark Arrester (18-2)