Filter
Top Products
SKU 94371 For technical questions, please call 1-800-444-3353 Page 5
Unpacking
When unpacking, check to make sure the following parts are included:
Impact Driver, Battery, Charger Base, and Charger Adapter.
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Operation
CHARGING BATTERY
The Battery (30) does not come charged from the factory. Charge before using.
Refer to photos on the next page.
1. Push the two side buttons in on the Battery, then slide the Battery off the
Impact Driver handle.
2. Slide the Battery into the Charger Base (48). The battery can only insert one
way using the guide tabs.
3. Plug the Charger Adapter (49) output cord into the Charger Base connector.
4. Plug the Charger Adapter line cord into an electrical outlet.
Verify on the Charger Base that the red charging indicator light come on. If it
does not come on, check the power connection or try a different wall outlet.
Charge the new Battery for 5 hours. Subsequent charges will take 4 to 5
hours.
5. Unplug the Charger Base from the electrical outlet when the Battery is fully
charged. The Charging Indicator will flash red.
Note: The operation time of a new battery will ramp up as it is properly used (drained)
and recharged. It will take about 5 recharging cycles before the Battery is at maxi-
mum efficiency.
Caution: If two or more batteries are to be charged, avoid damaging the Charger
by allowing it to cool down between charges. Wait for the Battery to cool down
before placing in the Impact Driver.