Harbor Freight Tools 94668 Work Light User Manual


  Open as PDF
of 4
 
Page 3For technical questions, please call 1-888-866-5797.Item 94668
12. Do not operate the Worklight in
explosive atmospheres, such as in the
presence of flammable liquids, gases,
or dust. Electrical products create sparks
which may ignite the dust or fumes.
13. Do not submerge in water
or any other liquid.
14. WARNING: The cord of this product
contains lead and/or di (2-ethylhexyl)
phthalate (DEHP), chemicals known
to the State of California to cause
cancer, and birth defects or other
reproductive harm. Wash hands
after handling. (California Health &
Safety Code § 25249.5, et seq.)
15. Warning: The warnings, cautions, and
instructions discussed in this instruction
manual cannot cover all possible
conditions and situations that may occur.
It must be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.
Assembly
1. Charge the Worklight before
using it for the first time.
2. Plug the AC/DC Adapter into the
Worklight at its base. Plug the AC/DC
Adapter to a 120V electrical outlet.
Adapter
Connection
3. Allow the Worklight to charge. Charging
Indicator Light is the bottom LED bulb
in center row. When Unit is charging,
Charging Indicator Light will glow
red. When Charging Indicator Light
glows green, unit is fully charged.
Disconnect the AC/DC Adapter.
4. The Worklight also has a cigarette lighter
adapter which can be plugged into a
vehicle’s cigarette lighter. Allow Batteries
to charge. Disconnect the Adapter.
5. To turn the Worklight on, press down
on the On/Off Switch. To turn the
Flashlight “OFF”, press down on the
opposite end of the On/Off Switch.
On/Off
Switch
6. The Cigarette Adapter contains one
250V, fast acting 3 Amp Fuse. To replace
the Fuse, make certain the Adapter
is unplugged. Open up the Cigarette
Adapter, remove Fuse and insert
new one. Close Cigarette Adapter.
7. The Worklight can be attached to metal
work surfaces by placing its magnetic
base against the metal portion of the
work surface. The Worklight can also be
hung by the Hanging Hook at its top. The
Hanging Hook swivels 360 degrees.
 previous