Filter
Top Products
SKU 95346 For technical questions, please call 1-800-444-3353 PAGE 6
When spills of fuel or oil occur, they must be cleaned up immediately. 3. Dis-
pose of uids and cleaning materials as per any local, state, or federal codes and
regulations. Store oil rags in a covered metal container.
Do not store fuel or other ammable materials near the Auger Drill.4.
Do not smoke, or allow sparks, ames, or other sources of ignition around 5.
the Auger Drill.
Keep grounded conductive objects, such as tools, away from exposed, live 6.
electrical parts and connections to avoid sparking or arcing. These events
could ignite fumes or vapors.
Do not rell the Fuel Tank while the Engine is running or while the Engine is 7.
still hot. Do not operate the Auger Drill with known leaks in the fuel system.
Use only Engine manufacturer recommended fuel and oil.8.
MECHANICAL PRECAUTIONS
Prior to performing service, maintenance, or cleaning procedures, allow the 1.
Engine to completely cool. Then, remove the spark plug from the Engine.
Do not alter or adjust any part of the Auger Drill or Engine that is assembled 2.
and supplied by the manufacturer.
Follow scheduled Auger Drill and Engine maintenance.3.
CHEMICAL PRECAUTIONS
Avoid contact with hot fuel, oil, exhaust fumes, and solid surfaces.1.
Avoid body contact with fuels, oils, and lubricants used in the Auger Drill and 2.
Engine. If swallowed, seek medical treatment immediately. Do not induce vomiting
if fuel is swallowed. For skin contact, immediately wash with soap and water. For
eye contact, immediately ush eyes with clean water.
WARNING: This product contains or, when used, produces a chemical 3.
known to the State of California to cause cancer and birth defects or other
reproductive harm. (California Health & Safety Code § 25249.5, et seq.)
NOTE: This item does not meet California CARB requirements and is not
for sale or use in California.
NOISE PRECAUTIONS
Prolonged exposure to high noise levels is hazardous to hearing. Wear
proper hearing protection when operating or working around the Auger Drill when
it is running.
REV 09b