Filter
Top Products
SKU 95504 Page 4
17. Guard against electric shock. Prevent body contact with grounded surfaces
such as pipes, radiators, ranges, and refrigerator enclosures.
18. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use
accessories intended for use with this tool. Approved accessories are
available from Harbor Freight Tools.
19. Do not operate tool if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
20. Use proper size and type extension cord. If an extension cord is required
for an air compressor, it must be of the proper size and type to supply the
correct current to the tool without heating up. Otherwise, the extension cord
could melt and catch fire, or cause electrical damage to the tool. This tool
requires use of an extension cord of 0 to 10 amps capability (up to 50 feet),
with wire size rated at 18 AWG. Longer extension cords require larger size
wire. If you are using the air compressor outdoors, use an extension cord
rated for outdoor use. (signified by “WA” on the jacket).
21. Maintenance. For your safety, service and maintenance should be performed
regularly by a qualified technician.
Note: Performance of this tool (if powered by line voltage) may vary depending on
variations in local line voltage. Extension cord usage may also affect tool perfor-
mance.
Warning: This product contains or produces a chemical known to the State of
California to cause cancer and birth defects (or other reproductive harm). (Cali-
fornia Health & Safety Code § 25249.5 et seq.).
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the
operator.
Special Warnings for This Tool
1. There are certain applications for which this tool was designed. Harbor Freight
Tools strongly recommends that this tool not be modified and/or used for any
application other than which it was designed.
22. Use clean, dry, regulated, compressed air at 90 PSI. Do not exceed the
recommended 90 PSI. Never use oxygen, carbon dioxide, combustible gases
or any other bottled gas as a power source for these tools.