Filter
Top Products
SAFETY WARNING & CAUTIONS
READ ALL INSTRUCTIONS BEFORE USING THIS STAND!
1. KEEP WORK AREA CLEAN. Cluttered areas invite injuries.
2. OBSERVE WORK AREA CONDITIONS. Do not use tools in damp, wet, or poorly lit locations.
Don’t expose to rain. Keep work area well lit. Do not use electrically powered equipment in the presence
of flammable gases or liquids.
3. KEEP CHILDREN AWAY. Children must never be allowed in the work area. Do not let them handle
machines, tools, or equipment.
4. STORE IDLE EQUIPMENT. When not in use, tools must be locked up in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
5. DO NOT FORCE OR MODIFTY THE STAND. It will do the job better and more safely at the rate
for which it was intended. Do not use inappropriate attachments in an attempt to exceed the Stand’s
capacities.
6.DESIGNED EXCLUSIVELY FOR USE WITH ITEM 43681--Gap Bed Lathe. STAND IS
UNSTABLE WITHOUT LATHE. Do not use with other machines or loads.
7. DRESS PROPERLY. Do not wear loose clothing or jewelry, as they can be caught in moving parts.
Non-skid footwear is recommended. Wear restrictive hair covering to contain long hair. Always wear
appropriate work clothing.
8. USE EYE, EAR AND BREATHING PROTECTION. Always wear ANSI approved impact safety
goggles if you are producing metal filings or wood chips. Wear an ANSI approved dust mask or respirator
when working around metal, wood, and chemical dusts and mists. Use ANSI approved ear protection
when working in a loud or noisy environment.
9. READ MANUAL. Read manual for the Stand and for the Lathe (SKU 43681) before assembly and/or
use.
10. DO NOT OVERREACH. Keep proper footing and balance at all times. Do not reach over or across
running machines.
11. ASSEMBLE AND INSTALL ON A LEVEL, FLAT AND CONCRETE SURFACE CAPABLE
OF SUPPOERTING STAND, LATHE AND ALL WORKPIECES. Bolt the Stand to the concrete
securely and ensure the Stand is square and stable berfore installing the Lathe.
12. DO NOT EXCEED THE MAXIMUM WEIGHT CAPACITY OF 1,320 POUNDS. Place Lathe
on Stand in a careful and controlled fashion; dropping the Lathe on the Stand may briefly create an excess
load, resutling in Stand failure and possible damage and/or personal injury.
Page 3 SKU # 95647