Filter
Top Products
Page 10SKU 97055 For technical questions, please call 1-800-444-3353.
Problem Possible Solution
Sander does not start. 1. Squeeze harder on Paddle Switch.
2. Make sure air compressor is set at 90 PSI.
3. Check for air leaks in air hose and all other compressed air
connections.
4. Remove Quick Connector. Check Air Filter in Air Inlet for excessive
debris build-up. If necessary, clean or replace Air Filter.
Sander will not remove material from
workpiece, even after repeated attempts.
1. Make sure Sanding Paper is not dull. If necessary, replace
Sanding Paper.
2. Use a more course grit Sanding Paper.
3. Do not continue using Sander to avoid damaging workpiece. Use
another method to remove material.
Sanding Belt slips off tool when in use. 1. Loosen the Belt Adjusting Screw. Stretch the Sanding Paper tighter
on the Adjusting Bar. Then retighten Adjusting Screw.
TROUBLESHOOTING
Part Description Qty. Part Description Qty.
1 Body (with Bushing) 1 27 Nut 1
2 O-Ring 1 28 Angle Head 1
3 End Cap 1 29 Ball Bearing 1
4 C-Ring 1 30 Bevel Gear 1
5 Air Filter 1 31 Ball Bearing 1
6 Paddle Switch 1 32 Chuck Casing 1
7 Spring Pin 1 33 Key 1
8 Brush 1 34 Cap 1
9 Valve 1 35 Belt Track 1
10 O-Ring 1 36 Adjusting Bar 1
11 Spring 1 37 Spring 1
12 Speed Regulator 1 38 Nut 2
13 O-Ring 1 39 Spring 1
14 O-Ring 1 40 Cap 1
15 Valve Screw 1 41 Belt Tensioning Screw 1
16 Ball Bearing 1 42 Ball Bearing 2
17 Rear Plate 1 43 Spindle 1
18 Spring Pin 2 44 Belt Wheel 1
19 Cylinder 1 45 Spring Washer 1
20 Rotor 1 46 Nut 1
21 Vane 4 47 Belt Wheel 1
22 Steel Ball 1 48 Washer 2
23 Front Plate 1 49 Oil Hole 1
24 Ball Bearing 1 50 Air Inlet 1
25 Connector 1 51 Hex Wrench 1
26 Bevel Gear 1 52 Clamp Screw 1
PARTS LIST
REV 08k