Filter
Top Products
Page 7SKU 97626 For technical questions, please call 1-800-444-3353.
Lock Button
Power Switch
1/8” Shank with
Bufng Wheel
Collar
5. Choose the right Shank for the job,
insert it into the correct size Collet and
place it into the Rotary Tool.
Place the Collar over the Shank and 6.
Collet, hold the Lock Button down,
and screw the Collar until it is tight.
Let go of the Lock Button. Pull on the
Shank to ensure that it is secure.
Push the accessory to be used onto 7.
the end of the Shank.
Plug the Power Pack into a standard, 8.
grounded 120V electrical outlet.
Plug the Rotary Tool into the connec-9.
tion on the Power Pack.
Turn the Power Switch “ON” and al-10.
low the Rotary Tool to come up to full
speed before beginning work.
Contact the material lightly. Do not 11.
press hard on the tool while working;
allow the tool to work at its own pace.
It is better to make several passes on
material than to try to remove a lot of
material in one pass.
To prevent accidents, turn off the 12.
tool and disconnect its power supply
after use. Clean, then store the tool
indoors out of children’s reach.