Filter
Top Products
Page 3SKU 98383 For technical questions, please call 1-800-444-3353.
Keep hands and feet away from Roll-5.
er Barrel when using. Never stand in
the direct path of the Roller.
Do not Use on wet, or damp lawn 6.
or dirt. Grass, mud and debris can
build up at Roller Barrel Axle and/or
against the Scraper Plate (6) causing
the Barrel to become hard to push.
Keep Children Away and never al-7.
low them to play with this Steel Lawn
Roller. All visitors should be kept at a
distance from work area. Keep pets
out of the work area.
When servicing use only identical 8.
replacement parts.
When not in use, store this Steel 9.
Lawn Roller Indoors.
Maintain Steel Lawn Roller with care. 10.
Keep Roller Barrel clean for best per-
formance. Inspect Steel Lawn Roller
periodically, and if damaged, have
it repaired by an authorized service
facility. Keep handles dry, clean, and
free from oil and grease.
Do not use this Steel Lawn Roller for 11.
other than intended use.
Maintain labels and nameplates on 12.
the appliance. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools
for a replacement.
The warnings, precautions, and 13.
instructions discussed in this
instruction manual cannot cover all
possible conditions and situations
that may occur. It must be understood
by the operator that common sense
and caution are factors which cannot
be built into this product, but must be
supplied by the operator.
SAVE THESE
INSTRUCTIONS.
SPECIFICATIONS
Construction
Roller Barrel: Formed, Round
Steel.
Upper and Lower Handle:
Formed Steel.
All Hardware: Carbon Steel.
Drain Plug: Hard Rubber.
Overall Height 42-1/2” High
Net Weight 23.40 LB (Empty)
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
ASSEMBLY
Mount the two Lower Handles (7) to 1.
the axle of the Roller Barrel (1) and
secure each side with a Cap Nut (3).
Mount the Top Handle (10) to the 2.
Lower Handles (7) using the Bolts (8)
and the Lock-Washer Nuts (9). Refer
to “Assembly Diagram” on page 6 for