Filter
Top Products
SKU 98917 For technical questions, please call 1-800-444-3353. Page 12
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn off the tool, detach the
air supply, safely discharge
any residual air pressure in
the tool, and release the
Trigger before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE:
Do not use damaged
equipment. If abnormal
noise, vibration, or leaking
air occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
Note: Anytime inspection, maintenance
and cleaning are done:
Disconnect the Floor Nailer from 1.
its air supply.
Empty the Magazine (71) complete-2.
ly.
Try to re the Nailer into a piece of 3.
scrap wood or ooring to ensure
that it is disconnected and inca-
pable of ring any nails/staples.
Inspect the air supply screen located 4.
in the End Cap (82) before each use.
Clean or replace as necessary. Dirt
in the air supply is a major cause of
pneumatic tool wear. Use a lter in
the compressed air system for better
performance and longer tool life. The
lter must have adequate ow capac-
ity for the specic application.
Clean the external parts of the Nailer 5.
with a clean cloth and mild detergent
or non-ammable solvent. Then dry.
Store in a clean, dry and safe location 6.
out of reach of children.
All maintenance, service or repairs
not listed in this manual are only
to be attempted by a qualied ser-
vice technician.
Record Product’s Serial Number
Here:
Note: If product has no serial number,
record month and year of purchase
instead.
Note: Some parts are listed and shown for
illustration purposes only, and are not
available individually as replacement
parts.