Filter
Top Products
SKU 99681 For technical questions, please call 1-800-444-3353. Page 10
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
power-strip to its “OFF”
position so that any power
tool plugged into it cannot be
accidentally turned on. Do
this before performing any
inspection, maintenance, or
cleaning procedures.
BEFORE EACH USE,1. inspect the
general condition of the bench.
Check for loose screws, misalignment
or binding of moving parts, cracked or
broken parts, damaged electrical wir-
ing, and any other condition that may
affect its safe operation.
AFTER USE,2. clean external surfaces
of the bench with clean cloth.
Vacuum Bench Top, wipe or brush 3.
clean.
The light xture mounted underneath 4.
the top shelf has a transparent plastic
cover over the bulb.
Gently pull straight down at both a.
ends of the cover and set aside.
Remove the bulb by spinning the b.
bulb 90º, rolling in a forward or back-
ward direction and dropping the bulb
straight down.
With the prongs on either end of the c.
bulb vertically aligned, t the new
bulb up into the slots at the right and
left xture receptacles.
Rotate the bulb lengthwise 90º again d.
to seat the bulb. Replace the clear
cover.
5. WARNING! If the supply cord
of this workbench’s light or power
strip is damaged, it must be re-
placed only by a qualied service
technician.