Filter
Top Products
Page 6SKU 45949
Transporting the Plasma Cutter
1. When moving the Plasma Cutter, the power must be shut off and disconnected.
2. Pull the Plasma Cutter by its handle and roll on its wheels.
3. Do not drag, pull, or lift the Plasma Cutter by it’s cables.
High Frequency Radiation
1. When cutting or welding, be aware that high frequency radiation may be produced
which can interfere with radio navigation, safety services, computers, and
communications equipment. Before operations, have a qualified electronics technician
check out that possibility.
2. Keep high frequency source doors and panels tightly shut. Keep spark gaps at the
correct settings. Use proper grounding and shielding to minimize the possibility of
interference. Keep all cables close together and close to the ground. Locate the
welding or cutting operation as far as possible from sensitive electronic equipment; or
have the electronic equipment shut down temporarily.
Electrical Shock Hazard
1. Electric shock could be fatal. Never touch exposed electrical parts.
2. Switch off and disconnect the power source before installing or opening the Plasma
Cutter.
3. Installation must be performed by a qualified technician.
4. Installation procedures must comply with the National Electric Code, and all other
relevant regulations.
Unpacking
When unpacking, check to make sure the following parts are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
3 - Electrodes (not shown)
3 - Nozzles (not shown)