Filter
Top Products
Page 3SKU 94076
For technical questions, please call 1-800-444-3353.
13. Stay alert. Watch what you are doing, use common sense. Do not operate any tool when you are tired.
14. Take caution as some woods contain preservatives such as copper chromium arsenate (CCA) which
can be toxic. When cutting these materials extra care should be taken to avoid inhalation and minimize skin
contact.
15. Check for damaged parts. Before using any tool, any part that appears damaged should be carefully
checked to determine that it will operate properly and perform its intended function. Check for alignment and
binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper
operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not
use the tool if any switch does not turn On and Off properly.
16. Guard against electric shock. Prevent body contact with grounded surfaces such as pipes, radiators,
ranges, and refrigerator enclosures.
17. Replacement parts and accessories. When servicing, use only identical replacement parts. Use of any
other parts will void the warranty. Only use accessories intended for use with this tool. Approved accessories
are available from Harbor Freight Tools.
18. Do not operate tool if under the influence of alcohol or drugs. Read warning labels on prescriptions to
determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the
tool.
19. Use proper size and type extension cord. If an extension cord is required, it must be of the proper size and
type to supply the correct current to the tool without heating up. Otherwise, the extension cord could melt and
catch fire, or cause electrical damage to the tool. This tool requires use of an extension cord of 0 to 10 amps
capability (up to 50 feet), with wire size rated at 18 AWG. Longer extension cords require larger size wire. If
you are using the tool outdoors, use an extension cord rated for outdoor use (signified by “WA” on the jacket).
20. Maintenance. For your safety, maintenance should be performed regularly by a qualified technician.
Note: Performance of this tool (if powered by line voltage) may vary depending on variations in local line
voltage. Extension cord usage may also affect tool performance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It must be understood by the operator that common
sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities,
contain chemicals known [to the State of California] to cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
- Lead from lead-based paints
- Crystalline silica from bricks and cement or other masonry
products
- Arsenic and chromium from chemically treated lumber
(California Health & Safety Code § 25249.5,
et seq.
)
Warning: The brass components of this product contain lead, a chemical known to the State of California to cause
birth defects (or other reproductive harm).
(California Health & Safety Code § 25249.5,
et seq.
)
Warning: Exposure to aluminum oxide (a dust generated from material removing processes) can result in eye,
skin and breathing irritation. Always use a NIOSH (National Institute for Occupational Safety and Health) approved
respirator and safety goggles. Avoid skin exposure. Proper ventilation in the work area is required.
Additional Rotary Tool Safety Warnings.
1. Make sure accessories are rated for the speed recommended for this tool.
2. Securely clamp workpiece as the Rotary Tool spins at very high RPM rates. Never hold a workpiece in your
hands.
3. Always disconnect the DC power source before changing accessories.
4. Do not grind or sand near flammable materials.
5. After use, do not touch the bit or collet until the tool has had enough time to cool off.