Healthyway 310645H Paint Sprayer User Manual


 
Warnings
4 310645H
WARNINGS
Pressurized Equipment Hazard
Compressed air can inject in skin. Air tubing rupture can cause injury if disconnected while under
pressure. To reduce risk of injury:
Never exceed maximum working pressure of any attachment.
Do not direct airstream at body.
Follow Pressure Relief Procedure, page 7 whenever you are instructed to relieve pressure, stop
spraying, service equipment, install or clean spray nozzle or disconnect or connect hose.
Cleaning Solvent Hazard with Plastic Parts
Use only compatible water-based solvents to clean plastic structural or pressure-containing parts. Many
solvents can degrade plastic parts to the point where they could fail. Such failure could cause serious
injury or property damage. See Technical Data on page 34 of this instruction manual and in all other
equipment manuals. Read fluid and solvent manufacturer’s warnings.
Moving Parts Hazard
Moving parts can pinch or amputate fingers and other body parts.
Keep clear of moving parts.
Do not operate equipment with protective guards or covers removed.
Pressurized equipment can start without warning. Before checking, moving, or servicing equipment,
follow the Pressure Relief Procedure in this manual. Disconnect power or air supply.
Personal Protective Equipment
Wear appropriate protective equipment when operating, servicing or when in the operating area of this
equipment to help protect yourself from serious injury, including eye injury, inhalation of toxic fumes,
burns and hearing loss. This equipment includes, but is not limited to:
protective eye wear
clothing and respirator as recommended by fluid and solvent manufacturer
hearing protection
•gloves
CAUTION
Water or material remaining in unit when temperatures are below freezing can damage pump and/or delay startup.
To insure water and material are completely drained out of unit:
• remove hose from material outlet,
• tip sprayer forward 45° to allow material (water) to flow out of pump inlet.
Before adding material or starting unit in cold weather, circulate warm water through pump.