Heath Zenith SH-5412 Work Light User Manual


  Open as PDF
of 16
 
3
598-1158-04
❒ Removetheexistinglightxture.
❒ Installthemountingstrapasshownusingtwoscrews
thattyourjunctionbox.
❒ Theplastichangercanbeusedtoholdthexture
whilewiring.Thesmallendoftheplastichanger
canbethreadedthroughtheholeinthecenterof
thecoverplate.Thesmallendthengoesintoone
oftheslotsonthemountingstrap.
❒ Route thelight control’s wires through the large
gasketholes.
❒ Twistthe junctionboxwiresandxturewirestogether
asshown.Securewithwireconnectors.
White to
White
Black to
Black
Junction box ground wire to
green ground screw on fixture.
Gasket
Mounting
Strap
Mounting
Bolt
Rubber
Plug
WARNING: Turn power off at circuit breaker
or fuse.
Wire the Light Control
Mount the Light Control
❒ Alignthelightcontrolcoverplateandcoverplate
gasket.Securewiththemountingbolt.
❒ Alignthethreeslotsinthedecorativeshellwiththe
lampholderpins.Pushtheshellinandthentwist
clockwisetolock.Repeatforothershell.
LockNut
To avoid water damage and
electrical shock, keep lamp
holders30°belowhorizontal.
❒ Adjustthelampholdersbylooseningthelocknuts
butdonotrotatethelampholdersmorethan180°
from the factory setting. When screwing in the
oodlamps,donotovertighten.
Keeplampsatleast
1"(2.5cm)fromthe
sensor.Donotallow
the lamps to block
thelens.Lens
❒ Pushtherubberplugrmlyintoplace.
❒ Ifawetlocationjunctionboxwasnotused,caulk
the wall plate mounting surface with silicone
weathersealant.
ShellSlot
 previous next