Filter
Top Products
19
en
Please refer to the information provided with the saw
blade for details of correct settings.
6.8 Adjusting the stroke rate ẍẻ
1. Set the stroke rate adjustment thumbwheel to a posi-
tion between 1 (slow) and 6 (fast).
Please refer to the information provided with the saw
blade for details of correct settings.
6.9 Adjusting the cutting angle
6.9.1 Setting the cutting angle ẍẍ
1. Unplug the supply cord from the electric socket.
2. Remove the dust removal system adaptor.
3. Release the screw.
4. Pull the baseplate slightly toward the front of the tool.
5. Set the baseplate to the desired angle according to the
scale on the tool.
6. Tighten the screw.
6.9.2 Resetting the cutting angle
1. Unplug the supply cord from the electric socket.
2. Release the screw.
3. Return the baseplate to the 0° position.
4. Push the baseplate back to its original position (toward
the rear of the tool).
5. Tighten the screw.
7. Operation
-CAUTION-
● The cutting edges of the saw blade
are sharp.
● The cutting edges may present a risk
of injury.
● Wear protective gloves.
-CAUTION-
● The sawing operation swirls up dust
and wood chips into the air.
● The dust and wood chips may be harm-
ful to the eyes and respiratory system.
● Wear protective goggles and breath-
ing protection.
-CAUTION-
● Operation of the tool creates noise.
● Excessive noise may damage the hear-
ing.
● Wear ear protection.
6.10 Offsetting the baseplate ẍẎ
To facilitate sawing close to edges, the baseplate can be
repositioned as follows:
1. Unplug the supply cord from the electric socket.
2. Release the screw.
3. Push the baseplate back as far as it will go.
4. Tighten the screw.
6.11 Anti-splinter insert ẍẏ
-NOTE-
The anti-splinter insert cannot be used with certain types
of saw blades (e.g. offset blades).
Use of the anti-splinter insert helps prevent splintering
of the surface when sawing wood materials.
1. Unplug the supply cord from the electric socket.
2. Press the anti-splinter insert into the baseplate from
below.
6.12 Low-friction baseplate cover
-NOTE-
Use the low-friction baseplate cover to avoid scratching
sensitive materials.
1. Unplug the supply cord from the electric socket.
2. Hook the cover onto the front edge of the baseplate.
3. Press the cover against the baseplate until it snaps
into place.
7.1 System
-NOTE-
● To achieve good cutting performance and ease the
load on the tool, always use blades that are in good
condition.
● Do not overload the tool.
-CAUTION-
● When working with the tool, always guide it away from
the body.
● Lift the tool away from the workpiece only after the
blade has come to a standstill.