Filter
Top Products
12
English
BEFORE CUTTING
1. Cutting a groove on the table insert.
A groove has to be cut in the table insert, before starting operation.
Secure a piece of wood about 5-1/2" (140 mm) wide to the table
with the vise assembly, to prevent the breakage of the table insert.
After the switch has been turned on and the saw blade has reached
maximum speed, slowly lower the handle to cut a groove on the
table insert.
CAUTION: Do not cut the groove too quickly; otherwise the
table insert might become damaged.
2. Checking the saw blade lower limit position
WARNING: To prevent an accident or personal injury, always turn off the trigger switch and
disconnect the power plug from the receptacle before adjustment.
Check that the saw blade can be lowered 1-5/8" to 1-21/32" (41 mm
to 42 mm) below the table insert.
If necessary, adjust as follows:
(1) Loosen the 8 mm lock nut on the 8 mm depth adjustment screw.
(2) Turn the 8 mm depth adjustment screw as necessary to set the
lower limit position. The saw blade goes up when the 8 mm
depth adjustment screw is turned counterclockwise and down
when it is turned clockwise.
(3) Once the adjustment is complete, fully tighten the 8 mm lock
nut.
NOTE: Before tightening the 8 mm lock nut, confirm that the
saw blade is adjusted so that it will not cut into the table.
3. Confirmation for use of sub fence
WARNING: In the case of left bevel cutting, turn the sub fence counterclockwise. Unless it is
turned counterclockwise, the main body or saw blade may contact the sub fence,
resulting in an injury.
This power tool is equipped with a sub fence. (See Fig. 1)
In the case of direct angle cutting and angle cutting, use the sub
fence. Then, you can realize stable cutting of the material with a
wide back face.
In the case of left bevel cutting, raise the sub fence up as illustrated
in Fig.9 and then turn it counterclockwise.
Fig. 7
Fig. 8
8 mm Depth
Adjustment
Screw
8 mm
Lock Nut
Table
Insert
Turn Table
Fig. 9
Fence (B)
Turn
Sub Fence