Filter
Top Products
6
When cutting the workpiece which has the dimension of
“*” there might be some possibility of the lower end of
the circular saw to touch with the workpiece, even if the
motor head is located at the lower limit position. Pay
attention when cutting the workpiece. For further details,
refer to “PRACTICAL APPLICATIONS” on page 13. Mount
the auxiliary board on the fence surface (Refer ( ) the
thickness of auxiliary board). Refer to "5. Cutting large
workpieces" on page 14 (Fig. 31).
STANDARD ACCESSORIES
12 3
45
Fig. 3
1 305 mm TCT Saw blade (1 piece) (For wood)
2 Dust bag (1 piece)
For how to use, refer to page 19.
3 Vise Assembly w/knob bolt (1 piece)
For how to use, refer to page 13.
4 17 mm BOX wrench (1 piece)
5 Holder (1 piece)
For how to use, refer this page.
6 Washer (C) (Only For Australia)
OPTIONAL ACCESSORIES...sold separately
1 Extension Holder and Stopper
2 Crown molding Vise Ass’y
(Include Crown molding Stopper (L))
3 Crown molding Stopper (L)
4 Crown molding Stopper (R)
NOTE
Accessories are subject to change without any
obligation on the part of the HITACHI.
APPLICATIONS
Wood and aluminum sash.
PREPARATION BEFORE OPERATION
Make the following preparations before operating the
power tool:
1. Installation
Fig. 4
Attach the power tool to a level, horizontal work bench
in accordance with Fig. 4.
Select 8 mm diameter bolts suitable in length for the
thickness of the work bench.
Bolt length should be at least 40 mm plus the thickness
of the work bench.
For example, use 65 mm or larger bolts for a 25 mm
thick work bench.
The holder attached to the rear of the base helps
stabilize the power tool.
Holder adjustment:
Loosen the 6 mm bolt with the 10 mm box wrench.
Adjust the holder until its bottom surface contacts the
work bench surface.
After adjustment, firmly tighten the 6 mm bolt.
Fig. 5
281 mm
9 mm
3 holes
256 mm
244 mm
281 mm
25 mm thick bench
Work bench 8 mm nut
8mm boltBase
6 mm Bolt
Move
Adjust the holder until its bottom surface contacts
the work bench surface.
Holder
03Eng_C12LSH_Eng 4/26/07, 5:32 PM6