Hitachi C 7YA Saw User Manual


 
English
6
Have defective switches replaced by the authorized service center.
Do not use tool if switch does not turn it on and off.
23. NEVER USE A POWER TOOL FOR APPLICATIONS OTHER THAN THOSE SPECIFIED.
Never use a power tool for applications other than those specified in the Instruction
Manual.
24. HANDLE TOOL CORRECTLY.
Operate the tool according to the instructions provided herein. Do not drop or throw the
tool. Never allow the tool to be operated by children, individuals unfamiliar with its
operation or unauthorized personnel.
25. CHECK FOR LIVE WIRES.
Avoid the risk of severe electrical shock by checking for live electrical wires that may be
buried in walls, floors or ceilings. The wires should be de-energized before work begins.
26. KEEP ALL SCREWS, BOLTS AND COVERS TIGHTLY IN PLACE.
Keep all screws, bolts, and plates tightly mounted. Check their condition periodically.
27. DO NOT USE POWER TOOLS IF THE PLASTIC HOUSING OR HANDLE ARE CRACKED.
Cracks in the tools housing or handle can lead to electric shock. Such tools should not
be used until repaired.
28. BLADES AND ACCESSORIES MUST BE SECURELY MOUNTED TO THE TOOL.
Prevent potential injuries to yourself or others. Blades, cutting implements and acces-
sories which have been mounted to the tool should be secure and tight.
29. KEEP MOTOR AIR VENT CLEAN.
The tools motor air vent must be kept clean so that air can freely flow at all times. Check
for dust build-up frequently.
30. OPERATE POWER TOOLS AT THE RATED VOLTAGE.
Operate the power tool at voltages specified on their nameplates.
If using the power tool at a higher voltage than the rated voltage, it will result in
abnormally fast motor revolution and may damage the unit and burn out the motor.
31. NEVER USE A TOOL WHICH IS DEFECTIVE OR OPERATING ABNORMALLY
If the tool appears to be operating unusually, making abnormal noises, or otherwise
appears defective, stop using it immediately and arrange for repairs by a Hitachi
authorized service center.
32. NEVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF.
Dont leave tool until it comes to a complete stop.
33. CAREFULLY HANDLE POWER TOOLS.
Should a power tool be dropped or struck against hard materials inadvertently it may
be deformed, cracked, or damaged.
34. DO NOT WIPE PLASTIC PARTS WITH SOLVENT.
Solvents such as gasoline, thinner, benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry
thoroughly.
35. WHEN REPLACING A COMPONENT PART, ADOPT THE SAME TYPE. When replacing a
component part with a new one, adopt the same type of new part. Also, never attempt
to repair a power tool yourself.
36. KEEP GUARDS IN PLACE AND IN WORKING ORDER. Never wedge of tie lower guard
open. Check operation of lower guard before each use. Do not use if lower guard dose
not close briskly over saw blade.
CAUTION: If saw is dropped, lower guard may be bent, restricting full return.