Filter
Top Products
English
11
APPLICATIONS
Rotation and striking function
⅜
Drilling anchor holes
⅜
Drilling holes in concrete
⅜
Drilling holes in tile
Rotation only function
⅜
Drilling in steel or wood
⅜
Tightening machine screws, wood screws
REMOVAL AND INSTALLATION METHOD
OF BATTERY
⅜
How to install the battery.
Align the battery with the groove in tool handle
and slip it into place.
Always insert it all the way until it locks in place
with a little click, If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you (Fig. 3).
⅜
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch (2 pcs) of the battery (Fig. 3).
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
⅜
The power source voltage is stated on the
nameplate.
⅜
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
ASSEMBLY AND OPERATION
Fig. 3
Latch
Handle
Insert
Battery
Pull out
Push
1. Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been inserted
into the receptacle, the charge status lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4. Make sure it contacts the bottom of the
battery charger.
3. Charging
⅜
When the battery is connected to the battery
charger, charging will commence and the charge
status lamp will light in red. (See Table 2)
NOTE:
If the charge status lamp flikers in red, pull out the
plug from the receptacle and check if the battery
is properly mounted.
⅜
When the battery is fully charged, the charge status
lamp will bilink in red slowly. (At 1-second
intervals) (See Table 2)
Battery
Charge status
lamp (red)
Overheat lamp (green)
Fig. 4
01Eng_DH18DL_US 4/26/07, 7:32 PM11