Filter
Top Products
English
11
APPLICATIONS
Rotation and hammering function
⅜
Drilling anchor holes
⅜
Drilling holes in concrete
⅜
Drilling holes in tile
Rotatio n only function
⅜
Drilling in steel or wood
⅜
Tightening machine screws, wood screws
Hammering only function
⅜
Light-duty chiselling of concrete, groove digging
and edging.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latches
to remove the battery (See Figs. 3 and 4).
2. Battery installation
Insert the battery aligning both guide rail of battery
and body. Make sure the battery is fixed firmly.
(See Fig. 4)
ASSEMBLY AND OPERATION
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
⅜
The power source voltage is stated on the
nameplate.
⅜
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1. Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been inserted
into the receptacle, the charge status lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 5. Make sure it contacts until the line is
visible.
Fig. 5
Fig. 4
Fig. 3
Latch
Guide rail of battery
Battery
Insert
Pull out
Housing
Guide rail of housing
Before insert
After insert
Line
01Eng_DH25DAL_US 9/14/07, 20:3911