Filter
Top Products
6
English
*Be sure to check the nameplate on product as it is subject to change by areas.
OPTIONAL ACCESSORIES (sold separately)
1. Drilling anchor holes (rotation + hammering)
Drill bit (Taper shank) and taper shank adapter
SPECIFICATIONS
STANDARD ACCESSORIES
(1) Plastic case.................................................................1
(2) Side handle ................................................................1
(3) Stopper........................................................................1
(4) Dust cup .....................................................................1
(5) Syringe ........................................................................1
Drill bit (Taper shank)
Taper shank adapter
(SDS-plus shank)
Cotter
Outer diameter
11.0 mm
12.3 mm
12.7 mm
14.3 mm
14.5 mm
17.5 mm
21.5 mm
Taper mode Applicable drill bit
Morse taper (No.1) Drill bit (taper shank) 11.0 ~ 17.5 mm
Morse taper (No.2) Drill bit (taper shank) 21.5 mm
A-taper Taper shank adapter formed A-taper or B-taper
is provided as an optional accessory, but the
B-taper
drill bit for it is not provided.
Voltage (by areas)* (110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V)
Power input 850 W*
No-load speed 0 – 850 min
-1
Full-load impact rate 0 – 3700 min
-1
Capacity: concrete 4 – 30 mm
steel 13 mm
wood 32 mm
Weight (without cord and side handle) 4.3 kg
Standard accessories are subject to change without
notice.
PRECAUTIONS ON USING ROTARY HAMMER
1. Wear ear protections
Exposure to noise can cause hearing loss.
2. Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
3. Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
4. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
5. Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
6. Wear a dust mask
Do not inhale the harmful dusts generated in
drilling or chiseling operation. The dust can
endanger the health of yourself and bystanders.