Hitachi GP 2 Grinder User Manual


 
15
English
CAUTION: Repair, modification and inspection of Hitachi Power Tools must be
carried out by a Hitachi Authorized Service Center.
This Parts List will be helpful if presented with the tool to the Hitachi
Authorized Service Center when requesting repair or other
maintenance. In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each country must
be observed.
MODIFICATIONS:
Hitachi Power Tools are constantly being improved and modified to incorporate
the latest technological advancements.
Accordingly, some parts (i.e. code numbers and/or design) may be changed
without prior notice.
ACCESSORIES
WARNING: ALWAYS use Only authorized HITACHI replacement parts and
accessories. NEVER use replacement parts or accessories which
are not intended for use with this tool. Contact HITACHI if you
are not sure whether it is safe to use a particular replacement
part or accessory with your tool.
The use of any other attachment or accessory can be dangerous
and could cause injury or mechanical damage.
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.
STANDARD ACCESSORIES
(1) Wrench (43/64’’(17mm)) (Code No.936638)...........................................................1
(2) Wrench (15/32’’(12mm)) (Code No.936553)...........................................................1
(3) Side Handle (Code No. 329758)..............................................................................1
OPTIONAL ACCESSORIES...........sold separately
Collet chuck (for 1/8’’(3.175mm) shaft)
Dimensions and handling methods other than the shaft hole are the same as
those for the 1/4’’(6mm) collet chuck.
Case
NOTE:
Specifications are subject to change without any obligation on the part of the
HITACHI.
01Eng_GP2_US 08/2/28, 20:4115