Filter
Top Products
3
27. STOP OPERATION IMMEDIATELY IF ANY ABNORMALITY IS DETECTED. Should the
power tool be detected as out of order or should other abnormalities be observed
during operation, stop using the power tool immediately.
28. NEVER LEAVE THE POWER TOOL RUNNING UNATTENDED. TURN POWER OFF. Don’t
leave the power tool until it comes to a complete stop.
29. CAREFULLY HANDLE THE POWER TOOL. Should the power tool be dropped or struck
against hard materials inadvertently, it may be deformed, cracked, or damaged.
30. DO NOT WIPE PLASTIC PARTS WITH SOLVENT. Solvents such as gasoline, thinner,
benzine, carbon tetrachloride, and alcohol damage and crack plastic parts. Do not wipe
them with such solvents. Wipe plastic parts with a soft cloth lightly dampened with
soapy water.
31. WHEN REPLACING A COMPONENT PART, ADOPT THE SAME TYPE. When replacing a
component part with a new one, adopt the same type of new part. Also, never attempt
to repair the power tool yourself. Bring it to an authorized service center for repair.
WARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other construction
activities contains chemicals known to the State of California to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products, and
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.