Filter
Top Products
English
28
ADJUSTING THE NAILING
DEPTH
To assure that each nail penetrates to the
same depth, be sure that the Nailer is always
held firmly against the workpiece.
If nails are driven too deep or shallow into
the workpiece, adjust the nailing in the
following order.
1 Remove the fuel cell and the battery from
the Nailer.
2 If nails are driven too deep, turn the
adjuster to the shallow side.
Adjustments are in half-turn increments.
If nails are driven too shallow, turn the
adjuster to the deep side.
3 Stop turning the adjuster when a suitable
position is reached for a nailing test.
4 Connect the fuel cell and the battery to
the Nailer.
ALWAYS WEAR SAFETY GLASSES.
Perform a nailing test.
5 Remove the fuel cell and the battery from
the Nailer.
6 Choose a suitable position for adjuster.
USING THE HOOK
CAUTION
ⅷ If the tool falls, there is a risk that
malfunction and/or physical damage
can occur.
It is recommended that you also use
fall–preventing wires, etc.
ⅷ Incomplete installation of the hook
may result in bodily injury when used.
Hook can be installed on the left or right side.
(1) Securely hold the main unit and
remove the screw using a screwdriver.
(2) Remove the hook and hook plate.
(3) Install the hook on the other side and
securely fasten with screw.
Fuel cell
Battery
Too Deep
Too Shallow
Turn Adjuster
Turn Adjuster
Flush
Flush
2
2
01Eng_NT65GS_US 12/17/08, 18:4728