Filter
Top Products
4
c) Do not position your body in the area where power
tool will move if kickback occurs.
Kickback will propel the tool in direction opposite
to the wheel’s movement at the point of snagging.
d) Use special care when working corners, sharp edges
etc. Avoid bouncing and snagging the accessory.
Corners, sharp edges or bouncing have a tendency
to snag the rotating accessory and cause loss of
control or kickback.
e) Do not attach a saw chain woodcarving blade or
toothed saw blade.
Such blades create frequent kickback and loss of
control.
SAFETY WARNINGS SPECIFIC FOR SANDING
OPERATIONS
a) Do not use excessively oversized sanding disc paper.
Follow manufacturers recommendations, when
selecting sanding paper.
Larger sanding paper extending beyond the sanding
pad presents a laceration hazard and may cause
snagging, tearing of the disc or kickback.
SAFETY WARNINGS SPECIFIC FOR
POLISHING OPERATIONS
a) Do not allow any loose portion of the polishing
bonnet or its attachment strings to spin freely.
Tuck away or trim any loose attachment strings.
Loose and spinning attachment strings can entangle
your fingers or snag on the workpiece.
PRECAUTIONS ON USING ELECTRONIC
SANDER POLISHER
1. Never mount a grinding wheel and attempt to use
this tool as a disc grinder.
2. Ensure the sanding paper is securely attached by
pressing firmly.
3. Never apply grinding fluid or water to the unit or
material during operation.
4. Always hold the body handle and side handle of
the power tool firmly
Otherwise the counterforce produced may result in
inaccurate and even dangerous operation.
SPECIFICATIONS
Voltage 240V
Power input 380 W
No load speed 7000 / min
Disc Size 150 mm
Weight (without cord, standard accessories) 2.1 kg
STANDARD ACCESSORIES
(1) Sanding Pad ..............................................................1
(2) Sanding Paper (#120 without hole)......................1
(3) Bar Wrench................................................................1
(4) Side handle ...............................................................1
(5) Hexagon Bar Wrench ..............................................1
(6) Dust Collection Set ..................................................1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES-sold separately
(1) Dust hose (1.5 m)
(2) Sanding Paper (with hole & without hole)
(3) Sanding Paper Punch
APPLICATIONS
Finishing of reparative coating of automobiles, painted
metal plates, etc.
⅜ Bordering between painted surfaces and metal
surfaces.
⅜ Polishing polyester patties.
Erasing letters, figures, etc., in reparative coating of
billboards.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Attaching sanding paper:
(1) As shown in Fig. 1, peel off the lining paper
beginning at the slit part. Ensure that the adhesive
on the back of the sanding paper does not become
fouled with dust or other foreign matter.
01Eng_SAY-150A_Eng 11/20/08, 11:124