Filter
Top Products
English
12
ASSEMBLY AND OPERATION
APPLICATIONS
Rotation and striking function
⅜ Drilling anchor holes
⅜ Drilling holes in concrete
⅜ Drilling holes in tile
Rotation only function
⅜ Drilling in steel or wood
⅜ Tightening machine screws, wood screws
REMOVAL AND INSTALLATION METHOD OF BATTERY
1. Turn the body upside down and hold it firmly. Then, open the plate assembly
while pulling the slide lever. (Fig. 3) To remove the battery, pull it out while
holding the body tightly. (Fig. 4)
2. Pay attention to the inserting direction of the battery, insert the battery, and
close the plate assembly. When the plate assembly and the slide lever engage
each other perfectly, there will be the sound of a click. (Fig. 5)
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
⅜ The power source voltage is stated on the nameplate.
⅜ The cord is not damaged.
WARNING: Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
Slide lever
Pull
Open
Plate ass’y
Rechargeable
battery
Pull out
Body
Rechargeable
battery
Plate
ass’y
Body
Slide lever
Close
Insert
Fig. 3
Fig. 4 Fig. 5