Filter
Top Products
English
19
6. Using depth gauge (Fig. 16)
(1) Loosen the knob on the side handle, and insert the
depth gauge into the mounting hole on the side
handle.
(2) Adjust the depth gauge position according to the
depth of the hole and tighten the knob bolt se-
curely.
7. How to use the drill bit (taper shank) and the
taper shank adaptor.
(1) Mount the taper shank adaptor to the rotary ham-
mer. (Fig. 17)
(2) Mount the drill bit (taper shank) to the taper shank
adaptor. (Fig. 17)
(3) Turn the switch ON, and drill a hole in prescribed
depth.
(4) To remove the drill bit (taper shank), insert the cot-
ter into the slot of the taper shank adaptor and
strike the head of the cotter with a hammer sup-
porting on the rests. (Fig. 18)
Front cap
Drill bit
Grip
Taper shank
adapter
Rests
Taper shank
adaptor
Cotter
Fig. 18
Mounting hole
Depth
gauge
Side handle
Fig. 16
Fig. 17