Filter
Top Products
OM-235 281 Page 21
3-15. Threading Welding Wire
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Outlet Wire Guide
7 Gun Conduit Cable
Lay gun cable out straight before
threading wire.
7
Tools Needed:
6 in
(150 mm)
. Hold wire tightly to keep it
from unraveling.
WOOD
Open pressure assembly. Pull and hold wire; cut off end. Push wire thru guides into gun;
continue to hold wire.
Close and tighten pressure
assembly, and let go of wire.
Lay gun cable out straight and
remove gun nozzle and contact tip.
Turn power ON.
Press gun trigger until wire
comes out of gun. Reinstall
contact tip and nozzle
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
Cut off wire approximately 5/16 in (8 mm)
from contact tip. Close door.
242 692-A
. Hold wire in groove before
closing pressure assembly.
Tighten
35
6
2
1
4
ON
OFF
POWER
ON