Hobart Welding Products 300 DC Welding System User Manual


 
OM-318 Page 14
1
2-10. Placing Jumper Links And Connecting Input Power
ST-130 173-K
Check input voltage available at
site.
1 Jumper Link Label
Check label only one is on unit.
2 Jumper Links
Move jumper links to match input
voltage.
3 Input And Grounding
Conductors
Select size and length using
Section 2-9.
4 Line Disconnect Device
Select type and size of overcurrent
protection using Section 2-9.
Reinstall side panel.
Y Special installation may be
required where gasoline or
volatile liquids are present
see NEC Article 511 or CEC
Section 20.
3/8 in
3/8, 1/2, 7/16 in
Tools Needed:
230 VOLTS
LL
460 VOLTS
LL
S-010 587-B
575 VOLTS
LL
230 VOLTS 460 VOLTS200 VOLTS
LL LL LL
S-083 566-C
GND/PE
Earth Ground
3
220 VOLTS
LL
380 VOLTS
LL
S-131 783-A
415 VOLTS
LL
2
L2 (V)
L1 (U)
4