Filter
Top Products
OM-186 165 Page 13
2-8. Installing And Threading Welding Wire
ST-800 586-B / Ref. ST-159 048-A / S-0627-A
1 Retaining Ring
2 Hub Tension Adjustment Nut
Installing Wire And Adjusting
Hub Tension:
Remove retaining ring, and install
spool so hub pin fits spool hole. Re-
install retaining ring.
Adjust tension nut so only a slight
force is needed to turn spool.
Threading Welding Wire:
3 Pressure Assembly
Adjustment Knob
Lay gun cable out straight.
A Open pressure assembly,
hold wire tightly, and cut off
end. Push wire through
guides into gun.
B Close and tighten pressure
assembly. Press gun trig-
ger until wire comes out
gun.
C Feed wire against wooden
surface, and tighten knob
so wire does not slip.
D Cut off wire, and close
door.
Tools Needed:
9/16 in
31
WOOD
Tighten
2
B
CD
A