Filter
Top Products
1 - 2
2. Connect the serial interface cable to the engine and to the matching
port on the back of the computer.
3. Connect the power supply connector to the serial interface cable.
Plug in the power supply.
4. Turn the terminal/computer power back on. The engine beeps. LED
D4 will light on the PC board. When the kit has finished initializing the
kit will beep once and LED D6 will flash once indicating the kit is ready
to use.
Note: All communication parameters between the engine and the terminal
must match for correct data transfer through the serial port using RS-
232 protocol. Scan the RS-232 interface bar code below. This
programs the Development engine for an RS-232 interface at
115,200 baud, parity-none, 8 data bits, 1 stop bit, and adds a suffix
of a CR LF.
RS-232 Interface