Filter
Top Products
General Operation
• The EG1400 is controlled by the on/off power control switch located
on the hose handle. The headlight will operate when the EG1400 is
turned on.
• To lower wand from the upright position, simply press on the handle
release pedal.
• The powerhead has a pile height pedal
for various carpet heights. (Fig. D) Select
a pile height setting by pressing the small
pedal on the rear of the EG1400. Use the
extra low setting for short napped carpets
and the high setting for plush carpets.
CAUTION: Do NOT leave the EG1400 running in one spot in the
upright position for any length of time. Damage to carpet may occur.
Attachments
Using attachments on the hose handle:
1. Press handle quick release button, then pull up on
handle. (Fig. E) NOTE: if the EG1400 is
attached, turn the powerhead off before removing
handle from wands.
2. Slide attachments firmly on hose handle as needed.
In some cases, the button may need to be
depressed to allow the attachment to slide up
higher where it can seal on the metal tube.
Using attachments on wands:
1. To remove the wands from the EG1400, lock wands
in straight-up position. (Fig. F)
2. Press wand quick release pedal with foot and pull
straight up out of the EG1400. (Fig. G) The plug
and cord do not have to be removed to use
attachments on wands.
3. Put attachment on wands as needed. In some cases,
the button may need to be depressed to allow the
attachment to slide up higher where it can seal on the
metal tube.
Fig. D
Fig. E
Fig. F
Fig. G