Filter
Top Products
Maintenance and Care
WARNING!!! Disconnect electrical supply before servicing or cleaning
the unit. Failure to do so could result in electrical shock or personal
injury from cleaner suddenly starting. Always follow all safety
precautions specified when caring for your EG1400.
To Remove Belt
1. Turn EG1400 upside down and unscrew the 2
cover screws. (Fig. H)
2. Turn EG1400 right side up. Press handle
release pedal and lower the swivel. Lift rear
latches up. (Fig. I)
3. To remove cover, grasp the side and pull out.
4. Depress tabs on rear of agitator cover and
rotate forward to release from the EG1400
base. (Fig. J)
5. Lift agitator assembly out and remove worn
belt. (Fig. K)
6. Check and clean end cap areas.
Fig. H
Fig. J
Fig. K
Belt Changing & Agitator Cleaning
Disconnect hose and brush from electrical outlet. Frequently check and
remove hair, string and lint buildup in the agitator and support areas. If
buildup becomes excessive, disconnect the EG1400 from the wand and
follow the steps below.
Fig. I