Filter
Top Products
6
REPLACING THE AREA LIGHT BULB:
1.This 12V bulb is designed to last for the lifetime of the product.
2.In the event of failure, you may return the spotlight to HUSKY for bulb replacement.
Contact HUSKY’s Technical Support Department at (800) 916-7004.
6. BATTERY:
•The life expectancy of the 12 Volt 3.0 Amp-hour, sealed lead-acid battery is approximately
500 charging cycles. A replacement battery may be purchased through the HUSKY
Technical Support Department by calling (800) 916-7004
•A fully-charged battery will provide approximately 20 minutes of continuous light from the
spotlight, or up to14 hours of continuous light from the area utility light
• Do not allow battery to completely discharge, a dim light indicates that the battery charge is
low, and should be recharged. Charge battery as soon as possible after each use; monitor
charge status by color
REPLACING THE BATTERY PACK:
All lead acid batteries fail over time and with extreme temperature changes. Keeping the
battery charged periodically will extend battery life to the maximum. Recharge after each use
as soon as possible using AC/DC recharge adapter as DC recharge methods may not fully
recharge the battery to its full capacity. If the battery does not operate the spotlight for more
than 10 minutes and recharge is sufficient to fully charge the battery, then it is time to replace
the battery.
1. Disconnect the SPOTLIGHT 2.25 from the Charging/Powering Source.
2. Make sure the Trigger Switch is turned OFF and locked.
3. Follow the lamp replacement procedures to step 10.
4. Carefully disconnect the positive and negative wires from the battery terminals, noting
the position of the wires.
5. Using a small Phillips head srewdriver remove 4 battery hold down strap screws.
6. Set the battery aside and insert the new battery taking care to MATCH UP THE PROPER
POLARITY - POSITIVE (red) to positive; negative (Black) to negative.
7. Attach wires to terminals.
8. Replace the battery hold down straps and screws (Do not over-tighten - clockwise)
9. Reassemble spotlight reflector by reversing the bulb replacement procedure.
10.Test the spotlight by operating the trigger switch. Charge the new battery for 20 hours
using the AC/DC Recharge Adapter.
Open
Closed
BULB
REPLACEMENT
FIGURE 4B
HAIRPIN RETAINING
WIRES