Husqvarna 343FRM Saw User Manual


 
ASSEMBLY
English 15
Assembling the handlebar and
throttle
CAUTION! Some models have the throttle handle fitted at
the factory.
Remove the screw at the rear of the throttle handle.
Slide the throttle handle onto the right side of the
handlebar, (see diagram).
Align the screw hole in the throttle handle with the hole
in the handlebar.
Refit the screw in the hole in the rear of the throttle
handle.
Screw the screw through the handle and handlebar.
Tighten it.
Unscrew the knob from the handlebar mounting.
Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness.
Tighten the knob.
Transport position, handlebar
The handlebar can easily be turned to fit along the
shaft for easier transportation and storage.
Loosen the knob. Turn the handlebar clockwise so that
the throttle handle rests against the engine.
Now twist the handlebar around the shaft. Tighten the
knob.
Fit the transport guard to the cutting attachment.
343FR, 343FRM
343F, 345FX, 345FXT
343R, 345RX