Husqvarna 343FRM Saw User Manual


 
ASSEMBLY
18 – English
Fitting the trimmer guard and
trimmer head Trimmy SII
Fit the correct trimmer guard (A) for use with the
trimmer head. Hang the trimmer guard/combination
guard (A) on the two hooks on the plate holder (M).
Bend the guard around the shaft and tighten it with the
bolt (L) on the opposite side of the shaft. Use the
locking pin (C). Place the locking pin in the groove on
the screw head and tighten. See diagram.
Fit the drive disc (B) on the output shaft.
Centre the metal cup (P) on the drive disc’s blade
guide.
Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
Insert the locking pin (C) in the hole to lock the shaft.
Screw on the trimmer head (H) in the opposite
direction to the direction of rotation.
Tighten the trimmer head to a torque of 35-50 Nm
(3.5-5 kpm).
To dismantle, follow the instructions in the reverse
order.
Fitting the shredder blade and the
shredder blade guard (343FRM)
Fit the holder (K) and bracket (J) with 4 bolts (H) on
the gear housing.
Then fasten the shredder blade guard (A) with 4 bolts,
washers and nuts in the holder as shown. The nuts
shall be tightened to a torque of 6 Nm (0.6 kpm).
L
A
M
C
B
H
P
C
H
C
J
K
H
A
x 4
x 4
x 4