Filter
Top Products
English – 11
ASSEMBLING AND ADJUSTMENTS
• Fit the support roller cover. Now tighten the four screws
fully.
• Rotate the blade and make sure that the support rollers
are not clamped against the blade.
• Adjust the adjuster screws so that the support rollers
make contact against the blade.
• Adjust so you can easily stop the support rollers using
your thumb when the blade is rotated. The support rollers
should only follow the blade occasionally.
• Tighten the locking nuts on the support roller guard.
• Rotate the blade and make sure you can still hold the
rollers with your thumb when the blade is rotated.
The machine shall stand upright when checking the roll
pressure. If the machine lies on its side the weight of the
blade makes it difficult to make a correct adjustment.
• Tighten the knobs fully and the machine is ready to use.
Water hose
Connect the water hose to the water supply. The water flow is
activated by opening the check valve. Minimum water flow: 4
l/min Note that the machine’s hose nipple is fitted with a filter.
CAUTION! Incorrect adjustment can result in damage to the
blade.
If the blade rotates slowly or stops, stop cutting immediately
and trouble shoot.