Filter
Top Products
[ 2 ]
It is recommended that you do not dry-fire (fire without paint) your Impulse. The Impulse has a low pressure
design, which makes the marker more accurate, and decreases ball breakage. Because of its low pressure
design, the marker requires a paintball in front of the bolt to produce back-pressure, which makes the mark-
er re-cock. If you must dry-fire the Impulse, remove the barrel and place a rag over the front portion of the
marker where the barrel screws into. This will simulate the paintball and create the required back-pressure
to re-cock the marker. If the Impulse is fired without anything in front of the bolt, the bolt will remain forward
and allow air to continuously drain down the barrel. If the bolt remains forward after firing the marker with
paint, increase the inlet pressure and decrease dwell settings.
The Impulse
TM
Paintball Marker is not a toy. Misuse or careless use may cause serious injury or death. The
user and any person within range must wear eye protection designed for paintball use. Recommended to
be at least 18 years old to purchase, 14 years old to use with adult supervision, or 10 years old to use on
paintball fields meeting ASTM standard F1777-97. Read operation manual before using. Always use a
barrel blocking device when not involved in actual play. When gassing and de-gassing the marker's system,
never aim the marker at another person. Always point the barrel towards the ground. Never use over-filled
CO2 bottles as this will "spike" the system causing the hoses to burst. Do not attempt to lighten or alter the
trigger assembly in any way, doing so will void your Smart Parts warranty. This includes any modifications
such as: spring removal, installing or adjusting set screws, and/or removing material from the trigger.
WARNING
IMPORTANT - Dry-Firing Your Impulse
TM
The Impulse Paintball Marker
The Impulse is an electro-pneumatic paintball marker designed to fire at a low operating pressure (150-200
psi) to reduce ball breakage and increase accuracy. Power is supplied to the marker by a standard
replaceable 9 volt alkaline battery that is housed in the grip frame. Paintballs are propelled by C02 gas or
compressed air, that is regulated by the Max-Flo regulator which supplies the required low pressure airflow
at a high volume. The Impulse consists of three main assemblies:
Body
The Body consists of two inter-linked systems; the
Bolt and the Firing System, which also includes an
air transfer port. The Bolt is contained in the upper
chamber, which is connected to the hammer in the
lower chamber by the bolt pin. The function of the
bolt is to load paintballs into the breech of the
marker and to transfer the air from the valve to the
ball in order to propel it.
Solenoid Housing
The solenoid housing serves three functions.
First, it encloses and protects the solenoid; second
it holds the circuit board, and third it connects the
body and the grip frame.
Grip Frame
The Grip Frame contains the trigger and battery.
The batteries are replaceable standard 9-volt alkaline.
Body
Solenoid
Housing
Grip Frame