Filter
Top Products
BASIC REMOTE CONTROL FOR START
M102
AND EMERGENCY RETRACT FUNCTIONS
12
‘OUT’ PORT
3-WAY PALM BUTTON VALVE (MODEL 461-2).
RED BUTTON WITHOUT GUARD lNSTANT TUBE
CONNECTIONS AND SPRING RETURN
‘PACKAGED 10 TO A BOX
REMOTE OPERATION
Remote operation of the unit may be achieved by Connecting a 3-way valve to the remote start and/or remote retract ports, as shown above.
TO START - depress the remote button momentarily. The unit will advance the drill to a preset depth and automatically retract to the initial position whereupon me unit will stop.
EMERGENCY RETRACT - depress the emergency button momentarily. This signal to the unit will shift the built-in pressure operated valve, commanding the unit to retract immediately
to the initial position whereupon the unit will stop.
NOTE: MANUAL START and EMERGENCY RETRACT buttons on the tool ore fully operational even when remote control is used. The manually operated buttons can be used when
set-up is required.
Shown below is the same system in schematic farm.
MODEL 8345-B( )-( )
CONNECTED 70 “IN” PORT
TH MALE CONNECTOR S9474-004
l
I-WAY VALVE (MODEL 5040-10 SHOWN)
2-POSITlON, MANUAL RETURN
1/8” N. P. T. F. PORTS
TUBING 59690( ). SEE TABLE
l
PACKAGED 10 TO A BOX
REMOTE OPERATION
Remote operation is achieved by connecting a 4-way valve to the remote start and retract ports as shown above. This valve supplies power directly to the feed piston in the tool.
TO START - move lever forward. The unit will advance to o preset depth (adjustment screw contacts stud on valve housing)
TO RETRACT - move lever rearward (back), The unit will retract to the initial position.
EMERGENCY RETRACT - the unit will retract at any time the lever is moved to the rearward (bock) position. The motor runs continuously as long as air pressure is present at the
air inlet to the tool. A shut-off valve should be installed in the air inlet Line to completely shut the tool off in case of an emergency.
Shown below is the some system in schematic form.
9